Naar de inhoud van de pagina

Metalen Stereo-Jack Connector

  • 3.5 mm connector met vergulde pinnen
  • Max. Kabel diameter: 8.4 mm
  • Kleur: Zwart
  • Leverbaar sinds Mei 2010
  • artikelnummer 249362
  • verkoopseenheid 1 stuk
  • Build In No
  • Type TRS (stereo/sym.)
  • angled No
  • Plug Jack 3,5 mm TRS male straight
€ 6,90
Alle prijzen incl. btw
Direct leverbaar
1

252 Klantenbeoordelingen

4.4 / 5

afwerking

105 Recensies

Ca
not easy to solder
Chris aus R. 30.11.2015
this good quality plug is a nightmare to solder on. It does not have the regular lugs, but simply tiny plug-ends that extend inward. The two hot leads are also very close together, making this a very tricky and finicky job. Once it is on, it is great and solid, though.
afwerking
0
0
Evaluatie melden

Evaluatie melden

B
Waardeloos, niet te solderen
Bashop 25.02.2019
Hier zitten hele kleine soldeer aansluitingen op, gaat nergens over. Dit is alleen door een chirurg te solderen. Ze liggen al in de prullenbak.
afwerking
0
1
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
G
Solid Plug, hard to solder
Gridnik 28.12.2025
Like others mentioned before me. The Plugs are really solid but hard to solder. With some time and patience I got it one fine but it definitely took me longer then normal plugs. I've red others gave up and I totally understand. If you are good at soldering it's likely it wint be a problem.

The plug themself are really solid, I'm using it now over 2 years and it's like new.
afwerking
0
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
A
Get your microscope out
Anoniem 22.01.2016
This is a good looking and sturdy connector, but it's a huge pain to solder to. There are no tabs or cups for the tip & ring connections, they are just concentric rods nested inside each other. I suggest pre-tinning everything and making the connection by reflowing with some extra flux. The ring connection and the housing (sleeve) are so close together that even with a pencil tip on the iron it's way too easy to bridge them together. But if you're feeling confident, go for it. FYI, a pair of SC Onyx 2025 cable does just fit into the strain relief if you lubricate the inside (with silicone grase / talcum powder) and play with it a little bit.
afwerking
1
0
Evaluatie melden

Evaluatie melden