Harley Benton DC-Junior FAT Faded Cherry

Na een lange research (maanden) besloten om deze gitaar te bestellen.
Bij het uitpakken was ik blij verrast, gitaar zag er goed uit, netjes ingepakt en behoorlijk goed afgesteld, de 0.10 snaren ben ik niet gewend te dun, ik speel al jaren 0.11. snaren vervangen na een week, en wat een verschil, lekkere dikke sound, de scherpte van de brug kan je snel aan wennen, weining anders dan mijn Gibson les paul.
het enige waar ik niet tevreden over ben is: het verschil tussen single mode en humbucking mode, in de humbucking mode is het volume lager, binnenkort ga ik hier mee aan de slag, kijken of ik de schakeling kan aanpassen.
Ik ben zeer tevreden over deze gitaar, veel waar voor je geld.
Ik ben bang dat mijn prs soapbar binnekort kan vertrekken (LOL)
Kortom: een aanrader.

This is a great DC JR for the money, and a good guitar overall. I’ve read complaints that the neck isn’t really fat- it’s almost identical to my 06’ Gibson SG special with the “rounded” profile and also very similar to my 2018 MIM fender telecaster. Its not like a Gibson slim taper. I think this really is very close to a 1959 Gibson profile. I get hand pain from slim necks and do not with this neck. I was able to lower the bridge almost all the way down, I could set it too low with too much fret buzz, the bridge definitely goes low enough. I changed to 9-42 strings, intonation can be dialed in using the saddles , without having to push the bridge away from the posts. Standing with a strap, the guitar is well balanced with no neck dive. I found the pickup a little quieter than the 490T in my SG, and installed a spacer and added foam under the pickup to raise its height which increased volume and fatness, but it’s still a little less powerful compared to my SG. I planned to swap it for a genuine p90, and I might some day, but the original sounds good. The push/pull coil split is quite noticeable using my OR15 even with a lot of gain, but I can only hear a difference with my Marshall valvestate using a clean setting. The tuning machines work fine, but I may replace them at some point. I like the volute, it’s a smart design and doesn’t get in my way playing. The finish is very flat and smooth, doesn’t seem to be open pore. The fret ends are smooth and frets level. The nut was cut well. The tone and volume pots give a good range of adjustment, though the tone pot has a very loose feel. I guess the only thing that separates this guitar from a more costly guitar is the wood-it feels light and low density. The lightness has it’s benefit, but it also feels a little cheap. However, it sounds and plays great, fully functional, very resonant, has great sustain, the neck feels solid, it stays in tune, it looks good, and is put together very well. It’s not just good for the price, it’s a good guitar. I bought this because I’m a fan of the Gibson double cut Junior design, and I wanted a guitar to use in E std tuning, drop D, and even drop A (Melvins/Kylesa), and it’s been great. It’s a great punk guitar as well as blues, rock, and even heavier sludgy sounds. I don’t think this would be the best choice for low standard tunings because the bridge would have to move back significantly to get good intonation with larger than 10-46 strings. After owning it a few months, I think it’s a keeper. Shipping to the US was incredibly fast, ordered Tuesday and arrived Friday. 100% satisfied and impressed.