Naar de inhoud van de pagina

Preamp/Booster schakelaar

  • Voor actieve en passieve pick-ups
  • Geschikt voor gitaren en bassen
  • Boost: 0 - 20 dB
  • 1 minischakelaar met schakelring
  • Leverbaar sinds November 2002
  • artikelnummer 158344
  • verkoopseenheid 1 stuk
€ 69
Alle prijzen incl. btw
Direct leverbaar
1

79 Klantenbeoordelingen

4.7 / 5

afwerking

40 Recensies

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
2
I love this one!
23cm 12.01.2014
This is a great product for giving the guitar the extra bite and mids.

A word of advice: when installing this, don't set the boost at maximum (you'll understand what I'm referring to when you're there). I had it on max and it just made the guitar sound terrible and over distorted (much like the "loudness-mastering" on Metallica's Death Magnetic). Begin at 50%, try the guitar throught the amp and adjust upwards if needed.
Also, think about this before installing it: do you want it to activate when flicking the switch down or up? If you know that, you can put it in the right position from the start.
I wish I had this boost in all my guitars...
afwerking
2
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
RS
Great but you need an electronics background ....
ROY STONE 14.01.2020
These are brilliant ..... I find that because of the amount of abuse the wiring of the entire guitar takes, you have be able to fault find electronics to do these & be prepared to repeatedly dismantle Strat guitars, which have no easy access panels, just the complete front panel, meaning removing the strings then a complete rebuild to test it
afwerking
0
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
S
Great on-board booster
SteveRob 05.06.2015
I used this to provide the active boost for an Andy Summers replica Telecaster I built.

It did a great job; I moved the trim pot to a full-size pot to control the boost level just like on Andy's guitar.
afwerking
1
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
A
Needed it to blend passive and active
Anoniem 18.03.2015
I got EM81 bridge and two passive.
So i needed a preamp for passives, because blending passive and active is a bad thing (tested it...horrible).
I used the other side of my selector for passives, and put PA2 at this side's output.
And soldered PA2 output and other side of selector output (EMG81 side) between them.

I put both PA2 and EMG81 at 18V (they handle up to 27V), and a 9V-18V switcher instead of tone knob (metalheads don't need tone knobs :D ).

Nice solution to avoid bypassing passive pickups or replacing them by active single coils.
afwerking
2
1
Evaluatie melden

Evaluatie melden