Allparts EP-0285-000 250k Push/Pull Pot

Relative small, so a bit tricky to solder, but on the other hand, does not take a lot of space inside the cavity of the guitar.

Build quality is perfectly fine. The threaded shaft is too long for mounting on pickguards without using 3 mm of washers to shim it down. Once installed, the pot works great.

The switch doesn't feel stiff but I have difficulty pulling it up with a plastic strat-style knob; I have to slide my finger nail under the edge of the knob to get enough grip. On stage? Forget it! Perhaps with a tele-style knurled metal knob it'll be easier, but that's not what I want on my guitar.

Great for the price. Nice and smooth operation

I bought this pot new and it arrived with a scratchy action and the push-pull operation is stiffer than the 500k pots that I purchased from Allparts.

Something that is annoying is that this potentiometer only comes with 1 nut, so you cannot height adjust like you can with many other pots. This feels like a miserly cost saving. It would also be great if the grounding tab had a hole through it, to allow a more secure soldering point for ground wires.

These are my go-to pots. Very reliable in my experience.

Build quality is good; taper is also good though the pot is a little too loose (turns too easily) for my tastes - some people may like this though. The push pull switch is of good construction and works as expected.

Sorry but the pot cuts out and generally didn't do what it said on the tin...